Jaga OXRE.015 Instructions D'installation page 87

9.4. CONNECTION COLLAR Ø125
This option makes it easy to connect to rigid hoses or
flexible ducts. This option can also be used in the standard
set up in particular when the walls are thicker than 500 mm
or the indoor walls have a very uneven surface.
Ordering code: 8800.4001
Attention: do not use another collar! Only use the Jaga
connection collar. Fit the Jaga collar withthe supplied
rivets (no screws!). .
9.5. FILTER
The Refresh Unit is fitted with a G3 Filter as standard. When indicated that the filter must be replaced,
a new G3 filter can be ordered using the following reference details.
Other types of filters are also available. For more information, please contact Jaga.
OXRE.015 / OXRE.020
OXRU.015 / OXRU.020
9.5.1. How do you replace a filter?
It is recommended that the provided filter be replaced after three months. This filter will be saturated
in a short period of time because of the 'construction dust' present, which will greatly increase the
filter's resistance. Please follow this recommendation to ensure that the device will work properly.
9.5.1.1. OXRE
01
The filter is located at the top of the device.
Pull the filter upwards and out of the device.
DIMENSIONS (LXBXH)
260x66x48 mm
350x100x48 mm
02
Install the new filter in the recess in the device.
Allow for the direction of the airflow. The arrows on the filter
must point from bottom to top.
ORDERING CODE
8800.1284
8800.1273
EN
87