Correcting Malfunctions; Spare Parts; Changing The Light Bulb; Noises During Operation - Electrolux ERT1000AOW Manuel D'utilisation

14 www.electrolux.com
The compressor
does not start
immediately after
changing the tem-
perature setting.
Water on the floor
or storage shelves.

CORRECTING MALFUNCTIONS

Spare parts

The following spare parts can be
ordered from your local AEG Service
Force Centre. You can fit these yourself
without any special skill ortraining, e.g.:
• butter/cheese compartment, egg
holders,
• door racks,
• fruit and vegetable drawers,
• storage racks.
A malfunction may be caused by only a
minor fault that you can rectify yourself
using the following instructions.

CHANGING THE LIGHT BULB

Warning!
There is a risk of electric shocks!
Before changing the light bulb,
switch off the appliance and
unplug it, or pull the fuse or the
circuit breaker.
Light bulb data: 220~240 V, max. 15 W
To switch off the appliance, turn the tem-
perature regulator to position "0".
Unplug the mains plug.
To change the light bulb, undo the
screw.
Press the light bulb cover as shown and
slide it backwards.
Change the defective light bulb. Refit
thelight bulb cover and the screw.
This is normal, no error has
occurred.
Water drain hole is
blocked.
The compressor starts after
a period of time.
See the «cleaning and
care» section.
Do not perform any other work on the
appliance if the following information
does not provide assistance in your
specific case.
Important!
Repairs to refrigerators/freezers
may only be performed by
competent service engineers.
Improper repairs can give rise to
significant hazards for the user. If
your appliance needs repairing,
please contact your specialist
dealer or your local Service Force
Centre.
Put the refrigerator back into operation.

Noises during operation

The following noises are characteristic
of refrigeration appliances:
Clicks
Whenever the compressor switches on
or off, a click can be heard.