Worx JAWSAW WG307 Mode D'emploi page 15

chain moving at full speed.
• Keep your JawSaw properly tensioned.
Check tension at regular intervals with the
motor stopped and the extension cord
disconnected.
When using the extended pole to cut the
branches on a tree, make sure to keep a firm
footing and balance. Do not stand in a position
where the branch may land after being cut.
When using this machine with the extension
pole, make sure that attaching the power
cord of the machine to the power cord of the
extension pole, and then attach the power
cord of the extension pole to power supply.
A retreat path should be planned and cleared
as necessary before cuts are started. The
retreat path should extend back and right
about the way the branch may fall down.
Before cutting is started, consider the natural
lean of the branch and the wind direction to
judge which way the branch will fall.
Remove dirt, stones, loose bark, nails, staples,
and wire from the branch where you plan to
make your cuts.
wArNiNG! The machine shall not be
used in any position that causes any
part to come within 33 feet (10m) of overhead
electrical lines;
wArNiNG! Some operating positions
are dangerous; the operator may be
struck by falling branches or by those that
rebound after hitting the ground. Remove the
branches in sections.
Keep bystanders and pets 100feet (30m) away.
Do not use this tool to cut branches or limbs
over 4 inches (10cm) in diameter, the branch or
limb must fit completely in the Jaw opening.
SAvE ThESE iNSTrucTioNS
General safety precautions for JawSaw
users
1. Fatigue causes carelessness. Be more
cautious before rest periods and towards
the end of your shift.
2. Personal protective clothing required by
your safety organizations, government
regulations, or your employer should be
used. At all times when using a JawSaw,
snug-fitting clothing, protective eyewear,
safety footwear, and hand, leg protection
Guarded electric chain saw
should be worn.
NoTE: Personal protective clothing
should meet the requirements of
applicable standards.
3. When cutting, keep at least 2 1/2 tree
lengths away from your fellow workers.
4. Plan your work, ensuring an obstacle-free
work area and, at least one escape path
from the falling branches.
5. Follow the instructions in your operator's
manual for starting the JawSaw and
control the JawSaw with a firm grip on
both handles when it is in operation.
Keep handles dry, clean, and free of oil.
6. Always transport JawSaw with the guide
bar and chain inside the protection guard.
7 . A JawSaw is intended for two-handed
use. Serious injury to the operator,
helpers, and/or bystanders can result
from one-handed operation.
8. See symbol definitions.
9. Keep other persons or animals a safe
distance away from a running JawSaw or
the area where a limb is being cut.
10. Use extreme caution when cutting small
brush and saplings because slender
material can catch the saw chain and be
whipped toward you.
11. When cutting a limb that is under tension
or compression, be alert for springback.
12. This electrically powered saw is classified
by CSA as a Class 2C saw. It is intended
for infrequent use by homeowners,
cottagers, and campers, and for such
general applications as clearing, pruning,
cutting firewood, etc.
Prolonged periods of operation can cause
circulatory problems in the user's hands
due to vibration. For such use, it may be
appropriate to use a saw having an anti-
vibration feature.
13. Do not use the JawSaw when you are
tired, ill or under the influence of alcohol
or other drugs.
14. Before you start the JawSaw make sure
the chain is not in contact with anything.
Stay alert! Watch what you are doing
and use common sense when operating
a power tool. Any small moment of
inattention while operating a power tool
15 15
en