Oase Water Trio Notice D'emploi page 16

- EN -
Operation
The manual transmitter as part of our scope of delivery is taught in for the 12 V control box. The 12 V control box has
to be adapted to every further manual transmitter.
Teaching-in manual transmitter (J):
The receiver is equipped with a teach-in button (24) to adapt the 12 V control box to the transmission signal of the
manual transmitter.
– Insert a pin (23) into the opening for the teach-in button (24) until you feel a resistance. Keep pressing in the
pin (23) until this resistance is overcome. The teach-in button (24) is then activated.
– Actuate the teach-in button (24) using the pin (23) for approx. 1 sec.
– Then press any button of the manual transmitter for at least 1 sec.
Deleting the manual transmitter (J):
– Actuate the teach-in button (24) using a pin (23) for at least 5 sec.
This deletes all manual transmitters stored in the receiver.
Note: A maximum of 10 manual transmitters can be set to the receiver. The manual transmitter has a maximum range
of 80 m. Obstacles between transmitter and receiver, a low battery in the manual transmitter, or electro-magnetic radia-
tion of electrical equipment will impair the range.
– Aligning the water jet (K):
– Adjust the individual movable nozzles to align the water jet (5).
16
the manual transmitter (A, 7) can be used to select 9 programmed water feature patterns.
Program 1 appears automatically when starting up and with each new start of the unit.
P0 Unit off, stand-by mode
P1 All fountains active, fixed height up to max. 30 cm
Light on for all fountains
P2 All fountains active, fixed height up to max. 70 cm
Light on for all fountains
P3 All fountains active, dynamic fountain height, max. 70 cm high
Light on for all fountains
P4 One fountain each alternatingly active in intervals, max. 70 cm high
Light switched on for each active fountain
P5 All fountains active, fixed height up to max. 110 cm
Light on for all fountains
P6 All fountains active, dynamic fountain height, max. 110 cm high
Light on for all fountains
P7 One fountain each alternatingly active in intervals, max. 140 cm high
Light switched on for each active fountain
P8 All fountains active, dynamic fountain height, max. 140 cm high
Light on for all fountains
P9 Several fountains alternatingly active, max. 140 cm high
Light switched on for the respective active fountains
Select next program: Button 1
Select previous program: Button 2
Note:
− If the unit is switched by means of a timer, always program 1 is started.
− Fountain heights can be varied.