Husqvarna ROYAL 43 Manuel De L'utilisateur page 11

Starting & Stopping
Royal 43
Starting
1. Connect the spark
plug lead.
2. Move the Engine
Speed Control to the
FAST ' ' position
before starting.(J1)
3. Pull the operator
presence control
(OPC) to release the
brake on the engine
and the blade.(J2)
4. Pull the recoil starter
fully towards you until
you feel the full
resistance, return the
handle slowly then
pull the handle firmly
towards you to its full
extent.(J3)
5. After the engine has
started, allow to run
for 30 seconds before
commencing to use.
Stopping
1. Release the OPC
lever.(J2)
THROTTLE CONTROL
(if fitted)
1. Fig. J4 represents the
FAST (run) position.
2. Fig. J5 represents the
SLOW (idle) position.
Starting & Stopping
Royal 43S
Starting
1. Follow steps 1-2 for
the Royal 43.
2. Pull the operator
presence control
(OPC) to release the
brake on the engine
and the blade.(J6).
3. Follow steps 4-5 for
the Royal 43.
USE
J1
J2
ROYAL 43
J3
J4
J5
J6
ROYAL 43S
Engaging the Drive
1. Forward drive is
engaged and
disengaged with the
Powerdrive lever at
the top of the
handle.(J7)
2. Releasing the
Powerdrive Lever
stops the forward
drive automatically.
Stopping
1. Release the
powerdrive lever.(J7)
2. Release the OPC
lever.(J6)
Starting & Stopping
Royal 43SE
Starting
1. Follow steps 1-3 for the Royal 43S
2. Turn the key and hold until the engine
starts.(J8) The key will return to the original
position when released.
3. If the engine fails to start when you turn the
key your battery may need charging.(See
page 7)
Engaging the Drive - See Royal 43S
Stopping - See Royal 43S
How to Mow
• Due to engine lubrication limitations, the
mower should not be used on slopes in
excess of 30°.
1. Start mowing from the outside edge of the
lawn, mowing in strips in alternate directions
2. Mow twice a week in the growing season,
your lawn will suffer if more that one third of
its length is cut at one time and this may
also result in poor collection.
Please Note:-
Do not overload your Lawnmower
When mowing in long thick grass a first cut with the
cutting height adjusted to its highest setting, see
Cutting Height, will help reduce engine overload
and will help prevent damage to your lawnmower.
Cutting Height
Adjustment
1. Pull the height
adjustment lever
away from the
location slots and
move it to the
selected position.(K).
J7
ROYAL 43S
J8
K
6 - ENGLISH