Worx landroid l1000 Manuel Du Propriétaire page 19

Landroid is starting to have shorter
run-times between charges.
Landroid is not operating at the
correct time.
Landroid cannot correctly dock
with the charging pile.
The green light on the charging
pile turns on before charging is
complete.
Landroid wheels skid or repeatedly
slip.
Landroid runs outside the boundary
wire.
Landroid does not mow an area
within a
boundary wire zone.
Landroid reverses or rotates
erratically near the boundary wire.
Landroid slips out of its working
area going down a hill.
Landroid operative system crashes
when charging or on standby.
Landroid shuts off when docking in
the charging pile.
18
Something is clogging in the blade disc
creating friction and increasing power
consumption.
Landroid is shaking heavily because the
blade disc is unbalanced.
The battery may be exhausted or old.
The working time is up
The clock is not set to the correct time.
Programmed cutting times for Landroid
are not correct.
the percentage of weekly operating time
set through APP has changed.
Environmental influences.
Poor connection caused by debris on
the charging strip.
the charging station is overheating or
overcooling
Foreign obstacles, such as twigs and
branches may be lodged under
Landroid.
The lawn is too wet.
The boundary wire of another Landroid or
robotic mower is positioned too closely.
In wet conditions, the boundary wire
electric signal may leak where the wire
has been joined or repaired incorrectly.
There is boundary wire electric signal
leakage due to broken insulation.
Low grip of Landroid drive wheels.
Software or display fault.
Landroid fails to charge due to over
temperature protection and is powered
off.
Poor connection.
Take off the blade disc and clean it. Maybe the
grass is too high and too thick.
Check the blade disc and blades,
remove debris and foreign objects from the
blades and blade disc.
Replace the blades with a new set.
Replace battery.
reset the working time
Set the clock to the correct time.
Change the time settings for the mower to start
and stop.
set the correct percentage through APP.
Restart Landroid.
Clean the contact pins located on the charging
pile and the charging strip on Landroid using a
cloth.
Place the charging station in a shady area or
wait until it reaches the normal temperature
Remove foreign objects from underside of
Landroid.
Wait until lawn has dried.
Ensure at least 1m clearance is provided in
between your boundary wire and that of your
neighbor.
Check boundary wire joints. Insulate to provide
a fully waterproof connection.
Repair damaged boundary wire
with the wire connectors supplied.
Please check the wheels are clean and free of
mud in order to have the
maximum grip possible.
Restart Landroid.
Place the charging station in a shady area or
wait until the temperature has cooled down.
Check the LED light on the charging pile. Check
the connection between the
contact pins located on the charging pile and
the charging strip.
EN