Cutting Warped Material; Clamping Wide Workpieces - Ryobi TS1345L Mode D'emploi

CUTTING WARPED MATERIAL

See Figures 33 - 34.
When cutting warped material, always make sure it is
positioned on the miter table with the convex side against
the fence as shown in figure 33.
If the warped material is positioned the wrong way as shown
in figure 34, it will pinch the blade near the completion of
the cut.
WARNING:
To avoid a kickback and to avoid serious personal injury,
never position the concave edge of bowed or warped
material against the fence.

CLAMPING WIDE WORKPIECES

See Figure 35.
When cutting wide workpieces, such as nominal 2 in. x 6
in., boards should be clamped with a C-clamp as shown in
figure 35.
RIGHT
OPERATION
WIDE
BOARD
Fig. 33
28 — English
WRONG
Fig. 34
Fig. 35