Ryobi TS1345L Mode D'emploi page 10

FEATURES
KNOW YOUR COMPOUND MITER SAW
See Figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
10 in. BLADE
A 10 in. blade is included with the compound miter saw.
LOCK
It will cut materials up to 3-1/2 in. thick or 5-1/2 in. wide,
PIN
depending on the angle at which the cut is being made.
BEVEL LOCK KNOB
See Figure 2.
BEVEL
LOCK
The bevel lock knob securely locks your compound miter
KNOB
saw at desired bevel angles. A positive stop adjustment
screw has been provided on each side of the saw arm.
These adjustment screws are for making fine adjustments
at 0 and 45 .
° °
"D" HANDLE
See Figure 3.
Fig. 2
For convenience when carrying or transporting the miter saw
from one place to another, a "D" handle has been provided.
To transport, turn off and unplug the saw, then lower the saw
LASER GUIDE
arm and lock it in the down position by depressing the lock
SWITCH
pin towards the saw housing.
NOTE: DO NOT perform any cutting operation with the saw
in the locked position.
ELECTRIC BRAKE
An electric brake has been provided to quickly stop blade
rotation after the switch is released.
"D"
LASER GUIDE
HANDLE
For more accurate cuts, a laser guide is included with your
miter saw. When used properly, the laser guide makes
accurate, precision cutting simple and easy.
LASER GUIDE SWITCH
See Figure 3.
Use the laser guide switch to turn the laser guide on and off.
MITER
MITER FENCE
LOCK HANDLE
The miter fence on the compound miter saw has been
provided to hold the workpiece securely against when
SAW ARM LOCKED IN DOWN POSITION
Fig. 3
making all cuts.
MITER LOCK HANDLE
See Figure 3.
The miter lock handle securely locks the saw at desired
miter angles.
10 — English