Installation Of The Exv Cable - Gree GMV-N140U/A-T Manuel D'installation Et D'utilisation

(4) Wrap the thermistor with insulating trip.
4.5.2 Air Thermistor
The air thermistor (RT1) can be installed in the space which needs temperature control, or the
inlet scoop of air handling unit.
Notes:
① For connection to outdoor unit and to AHU-KIT unit: Pull the wires inside through the
screw nut and close the nut firmly in order to ensure a good pull relieve and water
protection.
② The cables require an additional pull relief. Fixing the cable with the wire clamp.
③ The connection of thermistor requires enough space.

4.6 Installation of the EXV Cable

Referring to the circuit diagram, then connect the EXV cable to the circuit-board of control box.
Be sure that the cable is fixed firmly in order to ensure a good pull relieve and water protection.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
OPERATING INSTALLATION MANUAL FOR AHU-KIT UNIT
Fig.4.5.1.6
Fig.4.5.1.7
18