Location For Installation - Gree GMV-N140U/A-T Manuel D'installation Et D'utilisation

Capacity ranges of different AHU-KIT unit are as follows:
Model
GMV-N140U/A-T
GMV-N280U/A-T
GMV-N560U/A-T
Different capacities of same model of AHU-KIT unit are achieved through dialing capacity
code of mainboard (shown as "S1").Capacity code setting is shown as follows:
Please ensure dialing the code switch properly in place instead of middle position. Setting the
switch to "ON" stands for "0", otherwise stands for "1".
(Notes: The black part is the deflector rod.) The figure shows that the addresses of "1,2,3,4,5"
are "0,0,1,0,0".
Notes:
① The selected air handling unit must be designed for R410A.
② Extraneous substances (including mineral oils or moisture) must be prevented from
getting mixed into the system.

3.5 Location for Installation

Select an installation site where the following conditions are fulfilled and that meets your
customer's approval.
(1) The EXV box can be installed inside and outside. The control box should be installed
inside.
(2) Do not install the EXV box in or on the outdoor unit.
(3) Do not put the option boxes in direct sunlight. Direct sunlight will increase the
temperature inside the option boxes and may reduce its lifetime and influence its
operation.
(4) Choose a flat and strong mounting surface.
(5) Make sure there is enough free space in front and in the side of the AHU-KIT unit for
future maintenance.
(6) The installation site should be far away from heat source, inflammable gas and smoke.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
OPERATING INSTALLATION MANUAL FOR AHU-KIT UNIT
Acquiescent capacity (kW)
14.0
28.0
56.0
S1
1 2 3
0 0 1
0 1 1
0 0 0
1 1 0
1 0 1
1 0 0
0 1 0
1 1 0
Adjustable capacity (kW)
9.0/11.2/14.0
45/50.4/56
Capacity
4 5 (kW)
1 0 9.0
1 0 11.2
0 1 14.0
0 1 22.4
0 1 28.0
1 1 45.0
1 1 50.4
1 1 56
6
22.4/28