Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Copy
Use this function to copy the configuration settings, the schedule settings or both to other
EConnect™ wireless thermostats in your house. This function is available only if the
thermostat is connected either to a remote control or outdoor sensor. The settings are
copied to other thermostats connected to the remote control or outdoor sensor.
#
Display
1)
2)
3)
System test
1 From the Home screen, press
ambient temperature by at least 2°. Press Temporary.
2 Wait for Heat On to display on the thermostat.
3 Verify if the heater becomes hot.
4 Press Cancel to return the thermostat to its previous mode.
EConnect™ Wireless Thermostat Kit TL9160AR
Button
until the setpoint temperature is above the room
19
Step
From the installer's setup
menu, press
as needed to
select Copy and press OK.
Press
or
to select
Schedule, Configuration or
both. Press OK.
Wait may appear for several
minutes. When DONE
appears, press Exit to return
to home menu.
69-2474EFS—01
Publicité
Table des Matières
