Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Remote control or outdoor sensor
To replace the remote control or the outdoor sensor, install batteries in the new device
(see page 7) and link it to the wireless network (see page 10).
If more than one EIM are linked to the same thermostat, you can link the remote
control or the outdoor sensor from any one of these EIMs.
If you have more than one wireless thermostat, link the remote control or the outdoor
sensor from one EIM of each of the wireless thermostats.
Equipment interface module (EIM)
If you have a remote control:
1 Press and hold, for about 3 seconds, the blank space (or
arrow if present) in the lower right corner of the screen until
the display changes.
2 Press REMOVE, then YES.
If you have only one EIM linked to the thermostat:
Remove the defective EIM, install a new one (see pages 3 - 6) and proceed as follows:
1 Check if the thermostat displays 0 Driver(s) connected as shown on
the right. If so, go straight to step 5.
2 From the home screen, press and hold the right center button for 5 secs.
3 Press
to select Link and press OK.
to select Remove and press OK. The thermostat will display 0
4 Press
Driver(s) connected.
5 Follow the procedures on pages 7-11 to set up a new network with the new EIM.
If you have more than one EIM linked to the thermostat:
Follow the procedure below to identify the defective EIM(s) and to re-establish all links:
1 Remove the antenna cover from each EIM in the network by squeezing
the cover (as shown by red arrows) and pulling it out.
2 Press, for 10 seconds, the CONNECT button on every EIM that has a
green light. Repeat this step until none of the EIM shows a green light.
3 Check if the thermostat displays 0 Driver(s) connected as shown on the
right. If so, go straight to step 7.
4 From the home screen, press and hold the right center button for 5 secs.
to select Link and press OK.
5 Press
6 Press
to select Remove and press OK. The thermostat will display 0
Driver(s) connected.
7 Follow the procedures on pages 7-11 to create a new network. You
will know that an EIM is defective if its light turns red or the thermostat
displays an error code when you try to link the EIM to the network.
Replace it before continuing to link other EIMs.
EConnect™ Wireless Thermostat Kit TL9160AR
23
Press here
69-2474EFS—01
Publicité
Table des Matières
