Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1 Install the Equipment Interface Module (EIM)
Determine the location
The equipment interface module (EIM) consists of a relay and an antenna. They can be
installed either in the wiring compartment of the baseboard heater or in a 4-11/16" square
junction box.
Install EIMs at a minimum distance of 2 feet (0.6 m) of each other. This minimum
distance still applies even if the EIMs are on opposite sides of a wall.
• Installing the EIM in a baseboard heater
You can install the EIM in the wiring
compartment of the baseboard heater if you
have any of the heaters listed in the following
table:
Manufacturer / brand
Cadet
Global Commander
King Electrical
Marley
Ouellet
Stelpro
TPI
The product has been tested for compatibility with the heaters listed above. If your heater is
not on the list, install the EIM on a 4-11/16" square junction box or replace your heater with
one listed.
• Installing the EIM in a 4-11/16" square junction box
You can use a 4-11/16" square junction box in either of
the following conditions:
• You have a convector or fan-forced heater.
• You cannot install or do not wish to install the EIM
in the wiring compartment of the baseboard heater.
The junction box can be installed anywhere in the
house; for example, near the main electrical panel.
EConnect™ Wireless Thermostat Kit TL9160AR
Series
F
CCB
K, CB, KP, M
2500, BKOC, QMKC
ODBA, ODI, ODIA, OFM, OPR
CBB, N, SCA, SCAS
2900C, 2900S, 3700, 3900
3
Relay
Antenna
Relay
Antenna
69-2474EFS—01
Publicité
Table des Matières
