Installing The Grass Bag Adapter - Snapper 7800980-00 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING
Thrown Objects Hazard
DO NOT operate without entire Grass Catcher or guard in
place. Grass Catcher components are subject to deterioration
during normal use. Inspect frequently and replace worn or
damaged components immediately.

Installing the Grass Bag Adapter

(Optional Accessory on Some Models)
WARNING
Amputation Hazard
• DO NOT attempt any maintenance, adjustments or service
with engine and blade running.
• STOP engine and blade.
• Disconnect spark plug wire and secure away from spark
plug.
Burn Hazard
• Engine and components are HOT.
• Avoid serious burns, allow sufficient time for all
components to cool.
1. Remove the mulching cover. See Removing the Mulching
Cover .
2. Install the adapter (A, Figure 12) to the deck in place of the
mulching cover, making sure that:
• The front hole (B) on the outside front of the adapter
fits over the stud where the front of the mulching cover
was originally secured;
• The slot (C) on top of the adapter slips under the
restraining nut on top of the deck (under the right front
corner of the engine);
• The slot (D) on the rear of the adapter slips onto the
stud behind the rear of the discharge opening, where
the rear of the mulching cover was originally secured.
3. Install the internal/external tooth lock washers and knob
nuts onto the studs and tighten securely.
4. Route the recoil rope around the outside of the rope guide
pulley (E).
Note: The recoil rope may need to be slackened. See Starting
the Mower .
12
Installing the Mulching Plug
(Optional Accessory on Some Models)
WARNING
Amputation Hazard
• DO NOT attempt any maintenance, adjustments or service
with engine and blade running.
• STOP engine and blade.
• Disconnect spark plug wire and secure away from spark
plug.
Burn Hazard
• Engine and components are HOT.
• Avoid serious burns, allow sufficient time for all
components to cool.
1. Install the mulching plug (A, Figure 13) if mulching is desired
after the bag adapter is installed. Install the mulching plug
completely and securely into the bag adapter (B).
2. Install the grass bag as a safeguard and to further secure
the mulching plug.
WARNING
Thrown Objects Hazard
Install the grass bag when using the mulching plug. Failure
to do so may result in personal injury or death.
3. See Mulching Operation .
13

Publicité

Chapitres

Table des Matières
loading

Table des Matières