Handle Height Adjustment; Cutting Height Adjustment - Snapper 7800980-00 Manuel D'utilisation

Handle Height Adjustment

WARNING
Amputation Hazard
• DO NOT attempt any maintenance, adjustments or service
with engine and blade running.
• STOP engine and blade.
• Disconnect spark plug wire and secure away from spark
plug.
Burn Hazard
• Engine and components are HOT.
• Avoid serious burns, allow sufficient time for all
components to cool.
The height of the mower handle can be adjusted as follows:
1. Loosen the lower nuts (A, Figure 7) on each lower handle.
2. Move the handle assembly (B) up or down until the desired
position is achieved.
3. Tighten the lower nuts on each lower handle to maintain
the desired position.
7

Cutting Height Adjustment

WARNING
Amputation Hazard
• DO NOT attempt any maintenance, adjustments or service
with engine and blade running.
• STOP engine and blade.
• Disconnect spark plug wire and secure away from spark
plug.
Burn Hazard
• Engine and components are HOT.
• Avoid serious burns, allow sufficient time for all
components to cool.
1. Pull the height adjusting latch (A, Figure 8) outward and
move to the desired cutting height.
8
2. Set all wheels at the same cutting height. The highest cutting
position is Notch 7 (Figure 9). The lowest cutting position
is Notch 1.
9
11