Sentiotec PRO-C2 Instructions De Montage Et Mode D'emploi page 34

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Instructions for use for the user
Intensity regulation when the dimmer switch function is activated
When the dimmer switch function for the additional output is activated, the power
for the additional device can be set to a scale of 0 to 7. At 0, the additional device
is switched off. 7 corresponds to full power.
1. Turn the function selector 2 to position B (additional output).
► The additional output symbol lights up.
2. Use the intensity selector 3 to set the preferred power of the additional
device.
3. Press the intensity selector 3.
► The additional device switches on.
► The intensity selector 3 lights up.
Intensity regulation when the dimmer switch function is deactivated
When the dimmer switch function for the additional output has been deactivated,
you can only switch the additional device on and off. The device will always
operate at full power.
1. Turn the function selector 2 to position B (additional output).
► The additional output symbol lights up.
► In the intensity display, "OFF" appears.
2. Press the intensity selector 3.
► The additional device switches on.
► The intensity selector 3 lights up.
► In the intensity display, "On" appears.
Room temperature control with the additional output
If the mode of the additional output is set to room temperature regulation, a sauna
room temperature can be set, which is regulated using the additional output.
This can be used to regulate the sauna room temperature using only infrared
lamps or infrared heat plates.
WORLD OF WELLNESS
p. 34/48

Publicité

Chapitres

Table des Matières
loading

Table des Matières