Sentiotec PRO-C2 Instructions De Montage Et Mode D'emploi page 25

Installation instructions, only for experts
Activating/deactivating phase alignment
Phase alignment is activated or deactivated using the function selection switch 3.
● The function selection switch 3 is set to the ON position as standard. Phase
alignment is therefore activated.
● If you wish to deactivate phase alignment, place the function selection switch
3 in the OFF position.
Setting the light operating mode
The light for the sauna room can either be dimmed or switched on and off.
The dimmer switch function is activated or deactivated using the function selec-
tion switch 5.
● The function selection switch 5 is set to the ON position as standard. The dim-
mer switch function is therefore activated.
► To change the dimming characteristic, see "Changing the light dimming
characteristic" on page 29.
● If you wish to deactivate the dimmer function for the sauna room light, place
the function selection switch 5 in the OFF position.
Status output
The remote start function is activated or deactivated using the function selection
switch 7.
● The function selection switch 7 is set to the OFF position as standard. This de-
activates the status output.
● If you wish to activate the status output, place the function selection switch
7 in the ON position.
Setting the operating mode for the additional output
The additional output can either be regulated or switched on and off. The dimmer
switch function is activated or deactivated using the function selection switch 8.
● The function selection switch 8 is set to the ON position as standard. The dim-
mer switch function is therefore activated.
● If you wish to deactivate the dimmer switch for the additional output, place
the function selection switch 8 in the OFF position.
WORLD OF WELLNESS
p. 25/48
EN