PREPARING THE APPLIANCE READY FOR USE
Preparing the appliance ready for use
Before operating the appliance, fill the boiler to allow steam
to be generated:
- fill the bottle (I) with tip water; fig. 1
- remove the water tank cap (3) fig. 2
- turn the fill bottle (I) upside down on the tank opening;
fig. 2a
- fit the cap (3) back on the water tank.
-
a warning alarm indicates that water level is low
When the water tank is empty, an acoustic alarm will inform
you that after 4 minutes steam will not be released any more.
You need to fill the tank with water.
Filling the detergent tank
Pour tap water or foam-free detergents into the detergent tank
after lifting the fill cap (3) (Fig. 2b)
- a continuous warning alarm indicates that detergent level is
law.
- Remove the cover (1) of the waste container (2) as follows:
- Release the catch (b) by applying downward pressure in the
direction of the container; fig. (3)
- Press down the catch (a) while simultaneously lifting the cover
(1) fig. 3
- Fill the waste container (2) with tip water up to the filter level
mark (fig4) put the cover back on and engage the two catches
a+b ( catch b should be engaged in the body).Filling the
container with water ,will ensure that the air is filtered and any
impurities (dust ,mites,etc.) are trapped.
- For a correct use of the appliance, never reach the
MAX level mark with water indicated on the water
container. Fig. 4.
- Introduce the plug of the power cord (11) into the electrical
socket.
NOTE
Fig. 1
Fig. 2
Fig. 2 b
a
Fig. 3
Fig. 4
27
l
17
l
Fig. 2a
3
1
2
MAX
FILTER
b