Haussmann GGT600LU Manuel D'utilisation page 17

OPERATING INSTRUCTIONS
2. Auxiliary handle fitting (see fig 4)
NOTE: The handle may already be pre-
fitted to the trimmer. However the following
instructions give full assembly details.
Attach the auxiliary handle to the bracket,
note orientation. Insert the auxiliary handle
adjusting bolt through the handle and the
bracket and tighten the bolt clockwise.
3. Assembling the extandable arm support
(see fig 5)
The extendable arm support will make your
trimming job more comfortable.
Press the two buttons on the support shaft and
insert into the shaft into the top of the trimmer.
The support can now be extended or retracted
to the desired position.
PREPARING TRIMMER FOR USE
1. Adjusting Auxiliary Handle
The auxiliary handle can be adjusted to suit
the operator. To move the handle, release the
tension on the handle retaining bolt by turning
the knob counter-clockwise. Adjust the handle
to the desired position and retighten the bolt by
turning it clockwise. The handle is now locked
in the desired position (see fig. 6).
Fig 7
Fig 5
2. Adjust the height (see fig 7)
Turn the height adjustment locking knob
counter-clockwise to unlock. The telescopic
tube can now be moved up or down to achieve
a comfortable working height.
To lock the tube in position, turn the locking
knob clockwise.
Fig 8
3. Adjusting the extendable arm support
(see fig 8)
Pull the arm support outwards in order to
extend it to the desired length - so that
the support is underneath the elbow. The
extendable arm support is designed to provide
extra support for one hand trimming.
Fig 6
unlock
lock
A
17