DeWalt DW45RN Guide D'utilisation page 14

2. Keep the tool as warm as possible prior to use.
3. Make certain all fasteners have been removed from canister.
4. Put 5 to 7 drops of D WALT Pneumatic Tool Oil or winter weight
e
pneumatic oil containing ethylene glycol in the end cap.
5. Lower air pressure to 80 psi (5.5 bar) or less.
6. Reconnect air and load nails into canister.
7. Actuate the tool 5 or 6 times into scrap lumber to lubricate o-rings.
8. Turn pressure up to operating level (not to exceed 120 psi) and
use tool as normal.
9. Re-lubricate with D WALT Pneumatic Tool Oil or winter weight
e
pneumatic oil containing ethylene glycol in the end cap at least
twice a day or after 4 hours of use.
Hot Weather Operation
Tool should operate normally. However, keep tool out of direct sunlight
as excessive heat can damage bumpers, o-rings and other rubber
parts.
MAINTENANCE
WARNING: Disconnect air line from tool and remove fasteners
from magazine before making adjustments or personal injury may
result.
Daily Maintenance Chart
ACTION Lubricate tool with 5-7 drops of D
Tool Oil
WHY Prevents failure of o-rings
HOW Insert drops into air fitting on end cap of tool
ACTION
WHY
HOW
ACTION
WHY
HOW
ACTION
WHY
HOW
Cleaning
WARNING: DO NOT use gasoline or similar highly flammable
liquids to clean the nailer. Vapor could be ignited by a spark, causing
and explosion.
WALT Pneumatic
e
Tar and dirt may build up on the nose and trip lever preventing correct
operation. Remove any buildup with kerosene, #2 fuel oil or diesel fuel.
Do not dip the nailer into these solvents beyond the height of the nail
heads, to avoid solvent getting into the drive cylinder.
Dry off the nailer before use. Any oil film left after cleanup will
accelerate the tar build up and the nailer will require more frequent
cleaning.
12
Drain compressor tanks and hoses daily
Prevents accumulation of moisture in compressor and
nailer
Open petcocks or other drain valves on compressor
tanks. Allow any accumulated water to drain from
hoses
Clean canister, feed piston area and contact trip
mechanism.
Permits smooth operation of magazine, reduces wear
and prevents jams
Blow clean with compressed air. The use of oils or
solvents is not recommended as they tend to attract
debris
Before each use, check to ensure all screws, nuts and
fasteners are tight and undamaged
Prevents jams, leaks and premature failure of tool
parts
Tighten loose screws or other fasteners using the
appropriate hex wrench or screwdriver