Troubleshooting - Vileda robot Mode D'emploi

G
Problem
Robot does not detect cliffs.
Main brush does not work
properly.
Robot stops cleaning or does not
start cleaning and all light
indicators are flashing.
Central light indicator is flashing.
Robot only moves in circles in the
same position.
Timer does not work.
Robot cannot find the Charging
Station.
Robot does not start scheduled
cleaning.
Low Battery after charging for 12
hours
12

Troubleshooting

Possible reason
• Cliff sensors are dirty.
• Main brush got stuck and could
not rotate.
•Main brushes are jammed.
•Main brushes are incorrectly
assembled.
• Main brushes are jammed
• Drive wheels are jammed.
• Dustbin is not inserted correctly.
• Motor is defective.
• Low battery.
• One wheel is blocked.
• No battery or low battery.
• Timer is not synchronized.
• Distance between Timer and
robot is too big.
• Charging Station is not properly
connected to the mains.
• Charging station is covered by
any obstacle.
• Obstacle sensors of robot or
docking sensor of Charging
Station are dirty.
• Charging Station is not
synchronized.
• Battery of robot is totally empty.
• Remove the battery carefully and
insert it again.
• Robot is turned off.
• Robot is not physically
connected to the power station.
• Weekday for autonomous
cleaning is not selected.
• Charger or battery is defective.
Possible solution
• Clean the sensors with a dry
cloth.
• Clean main brushes.
•Insert main brushes correctly.
• Clean main brushes and
restart.
• Clean drive wheels and restart.
• Insert dustbin and restart
• Contact Vileda Service (see
last page).
• Recharge battery.
• Remove hairs and dirt from
wheels.
• Insert charged battery.
• Synchronize Timer (see section
"Using the Product").
• Ensure that distance between
Timer and robot is less than
10m.
• Plug the charger correctly to
the mains and to the Charging
Station and check if power
indicator lights up.
• Ensure there is no obstacle
within 3m in front of the
charging station and within
0.5m from its side.
• Clean the sensors with a dry
cloth.
• Synchronize Charging Station
(see section "Battery Charging
& Recharging").
• Charge the robot once
manually.
• Turn the robot on by pressing
the power switch.
• Connect the robot to the power
station (see section "Battery
Charging & Recharging").
• Select weekday for autono-
mous cleaning (see section
"Using the Product").
• Contact Vileda Service (see
last page).