Removing The Unit - Kenwood DPX308U Guide De Démarrage Rapide

Removing the Unit

Removing the hard rubber frame
1
Engage the catch pins on the removal
tool 4 and remove the two locks on the
lower level.
Lower the frame and pull it forward as
shown in the figure.
Lock
Removal tool (Accessory
⁄
• The frame can be removed from the top
side in the same manner.
2
When the lower level is removed, remove
the upper two locations.
14 | Quick Start Guide
Catch
)
4
Removing the Unit
1
Remove the hard rubber frame by
referring to the removal procedure in
the section <Removing the Hard Rubber
Frame>.
2
Insert the two removal tools 4 deeply
into the slots on each side, as shown.
3
Lower the removal tool toward the
bottom, and pull out the unit halfway
while pressing towards the inside.
¤
• Be careful to avoid injury from the catch
pins on the removal tool.
4
Pull the unit all the way out with your
hands, being careful not to drop it.