S2 Installation; Removing The Existing Acoustic Collar; Connecting The Antenna Cable - SCHUBERTH SRC-SYSTEM POUR CASQUES S2 Manuel De L'utilisateur

5. S2 INSTALLATION
(See section 6 for C3PRO installation instructions)

5.1 REMOVING THE EXISTING ACOUSTIC COLLAR

First, remove the existing Acoustic Collar from your helmet as follows:
Pull out and remove the Acoustic Collar from the front at its bent center.

5.2 CONNECTING THE ANTENNA CABLE

Your SRC-System™ has an antenna cable which must be connected to the built-
in antenna cable connector in the Schuberth helmet.
NOTE: Make sure to close the cover of the USB
connector, and then tuck it away into
the USB connector pocket.
1. Pull out the antenna connector (marked with a red tag) which is tucked inside
the back rim of the helmet.
Antenna tag visible
Antenna connector
pulled out
2. On the SRC collar open the two fasteners
on the antenna connector and remove the
protective plastic cover.
3. On the helmet remove the rubber
protector from the antenna
connector.
4. Align the two connector heads and snap the two fasteners back into place to
lock the connector in a closed position.
5. The antenna connector can now be
safely stowed away inside the antenna
connector pocket on the center of the
SRC-System™.
A. B.
A.
B.
7