Making Intercom Calls; Receiving Intercom Calls; Voice Connect Feature (Vox) - SCHUBERTH SRC-SYSTEM POUR CASQUES S2 Manuel De L'utilisateur

9.4b. THREE-WAY INTERCOM
The SRC-System™ offers three-way intercom conference connectivity as follows:
Use Channel "A"
Rider "2"
In this configuration Rider "1" is paired to Rider "2" and to Rider "3".
IMPORTANT: Since Rider "1" uses two Bluetooth® connections during the conference
mode, Rider "1" will be disconnected from the mobile phone or GPS device until the
conference mode ends. Then, Rider "1" will automatically re-connect to his mobile
phone or GPS. Riders "2" and "3" remain connected to their mobile phones or GPS
devices during the 3-way intercom call.
Pairing three SRC-System™ headsets is achieved by simply repeating the procedure in
the above section 9.4a with a third SRC-System™ headset (in a different CHANNEL).
1. Pair your SRC-System™ with the second SRC-System™ as described in
section 9.4a (Using CHANNEL "A").
2. Pair your SRC-System™ with the third SRC-System™ as described in
section 9.4a (Using CHANNEL "B")
18
Use Channel "B"
Rider "3"
Rider "1"

9.5 MAKING INTERCOM CALLS

There are two ways to start an Intercom call with headsets that are paired to your
SRC-System™ (make sure you are in Standby mode):
VOICE CONNECT (VOX):
Preferred for relatively brief conversations as it takes the
channel into standby mode after 30 seconds of silence
Start talking loudly
Once you start talking loudly, an Intercom call will be
established with both paired headsets, CHANNEL "A"
and CHANNEL "B" (if both are available).
The Intercom call will stay on until all participants
remain silent for 30 seconds. (Applicable for 2-way
communication)
NOTE: While the Intercom is on, the Redial and Voice Dial functions will be disabled.

9.6 RECEIVING INTERCOM CALLS

When a paired headset calls you via intercom, the call will begin almost instantly.
NOTE: The headsets preset priority modes have been set in a way to avoid incoming
intercom calls from interrupting mobile phone calls and GPS instructions in progress.
In such case the intercom caller will hear a busy signal and you will hear two beeps,
indicating that an intercom caller is trying to page you. (see section 4.6 for details on
audio priorities of paired devices).

9.7 VOICE CONNECT FEATURE (VOX)

The SRC-System™ also offers VOX technology for safe and hands-free operation
of some key functions.
The VOX feature can be customized to adjust its sensitivity level. You can choose
between 'Regular' (default), 'Low' and 'High' VOX sensitivity. If you experience
difficulty starting a conversation using VOX, change the setting to 'High' via the
PC software (see section 4.3) or directly on your SRC-System™ headset via the
Settings Customization Menu (see Section 4.4).
CHANNEL BUTTON
CONNECT:
Preferred for extended
conversations as it leaves the
channel open and active
Tap CHANNEL "A" or "B"
Button once to add or
remove the other headset
from an Intercom call.