Gps Device; Mp3 Music - SCHUBERTH SRC-SYSTEM POUR CASQUES S2 Manuel De L'utilisateur

7.2 GPS DEVICE

To use a Bluetooth® enabled GPS device with the SRC-System™, you
must first pair the two devices. This will allow your GPS to transmit
navigation instructions and audio to the speakers of your headset.
NOTE: Not all Bluetooth® GPS devices allow connections to Bluetooth® audio devices.
Please consult your GPS User Guide for more information.
PAIRING THE HEADSET TO A GPS DEVICE:
1. Turn on your GPS and turn on your headset.
2. With the SRC-System™ turned ON, press and hold the Volume Up Button for at
least six seconds until the Red and Blue Lights begin flashing simultaneously.
3. Search for Bluetooth® devices on your GPS by following the instructions in
the GPS User Guide. After a few seconds the GPS will list "SRCS" (incl. its
software version) as a discovered device. Select it and follow your GPS's
instructions to accept the pairing.
4. If your GPS device prompts for a PIN or Passkey enter 0000 (four zeros).
5. Your GPS device will confirm that pairing has succeeded. Your SRC-System™
will begin flashing slowly in Blue.
IMPORTANT
If you wish to use a Bluetooth® mobile phone to make and receive calls through the
headset, you should pair your mobile phone to your GPS device by following the
instructions in your GPS User Guide.
NOTES:
1. If the pairing process is not completed within two minutes the headset will return
to Standby mode
2. The priority schedule of your SRC-System™ has been set in a way to avoid
incoming intercom calls to interrupt GPS instructions in progress. In such case the
intercom caller will hear a busy signal and you will hear two beeps, indicating
that an intercom caller is trying to page you (see section 4.6 for details on audio
priorities of paired devices).
14

7.3 MP3 MUSIC

7.3a WIRELESS A2DP
Your headset is designed to receive wireless stereo music from A2DP sources and
mobile phones that support the Bluetooth® A2DP and AVRCP profiles (mostly 3rd
generation devices).
Using a Bluetooth® device that supports the AVRCP profile will allow you to
operate all major A2DP source functions directly from your headset.
NOTE: The SRC-System™ can also receive audio via the enclosed cable from non-
Bluetooth® MP3 Players or audio sources as described in section 7.3b
While listening to music from an A2DP source, you will not miss any mobile or
intercom calls, as the headset will automatically stop the music giving preference
to the incoming call. However, after you terminate your call, some MP3 sources
may not automatically continue but require manual re-activation.
SETTING UP YOUR MP3 PLAYER FOR BLUETOOTH STEREO A2DP
TRANSMISSION
To use a Bluetooth® Stereo (A2DP) enabled MP3 Player to listen to stereo music,
you must first pair the device to your headset.
PAIRING THE HEADSET TO AN MP3 PLAYER
NOTE: If your A2DP source is integrated inside your Mobile Phone, then you should
pair it with your headset as described in section 7.1 above
1. Turn on your MP3 Player and make sure that its Bluetooth® function is activated.
2. With the SRC-System™ headset turned ON, press and hold the Mobile Button
for at least six seconds until the Red and Blue Lights begin alternating rapidly:
3. Search for Bluetooth® headsets on your MP3 Player by following the device's
instructions.
4. After a few seconds the MP3 Player will list "SRCS" (incl. its software
version) as a discovered device. Select it and follow your MP3 Player's
instructions to accept the pairing.