Built-In Fm Radio - SCHUBERTH SRC-SYSTEM POUR CASQUES S2 Manuel De L'utilisateur

5. If your MP3 player prompts for a PIN or Passkey enter 0000 (four zeros).
6. Once pairing is complete, your MP3 Player may confirm that pairing has suc-
ceeded, and the headset will begin flashing slowly in Blue.
NOTE: If the Pairing process is not completed within two minutes the headset will
return to Standby mode.
OPERATING YOUR A2DP SOURCE FROM YOUR HEADSET
Play Press the MP3 Button for 3 seconds
Pause / Stop*
Press the MP3 Button for 3 seconds
Forward Press the Volume Up Button for 3 seconds
Rewind** Press the Volume Down Button for 3 seconds
* Varies depending on your mobile phone
** With some phones you may need to repeat this action once more
SWITCHING BETWEEN A2DP AUDIO SOURCES
If a Music Player is paired, the SRC-System™ will use it as the default A2DP audio
source.
1. Stop the music playback from the current device.
2. Start music playback from the other device.
7.3b CABLE-CONNECTED MP3 PLAYER VIA THE AUX
Your headset allows you to connect non-Bluetooth® audio sources, such as MP3
players to the headset by using the enclosed cable.
1. Make sure the headset is on Standby mode, flashing slowly in Blue.
2. Connect the MP3 cable to your MP3 player/audio source's headset jack and
insert the other end of the cable into the
micro USB Connector.
3. Operate the MP3 Player device by using its
own buttons as usual (FF / REW / PLAY / PAUSE).
Volume can be adjusted through the MP3 Player or the Volume Buttons of the
headset.
Any other audio connection will automatically mute the MP3 Player. The audio
signal will return only when headset is once again in Standby mode.
NOTE: While listening to your MP3 player, the VOX feature is disabled
8. BUILT-IN FM RADIO
The SRC-System™ is equipped with an FM stereo radio receiver and RDS (Radio
Data System) technology.
Radio On / Off Press and hold the CHANNEL "B" button for 3 seconds
Switch to next While listening to the Radio, tap the CHANNEL "B" button
preset station
to cycle through the 6 Preset FM Stations
Start Intercom call While listening to the Radio, start talking loudly
Initiate Voice Dial While listening to the Radio, tap the Mobile Button and
from your Mobile
pronounce loudly the name of the person you wish to
Phone call. This feature is supported only by mobile phones that
include the Voice Dial feature
Initiate Redial from
While listening to the Radio, tap the Mobile Button twice
your Mobile Phone
RDS ON/OFF While the Radio is on, press and hold Volume Up and
(Default: OFF) Volume Down Buttons simultaneously for 3 seconds
Thanks to the RDS feature, your headset will automatically select the strongest
signal available for the FM station you wish to listen to, no matter where you are
riding.
15