Charging The Headset; Important; Basic Setup And Configuration; Basic Functions - SCHUBERTH SRC-SYSTEM POUR CASQUES S2 Manuel De L'utilisateur

Masquer les pouces Voir aussi pour SRC-SYSTEM POUR CASQUES S2:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. CHARGING THE HEADSET
Make sure that your headset is fully charged for at least four hours
before initial use.
1. Open the cover protecting the Charging Jack.
2. Insert the USB cable into the Charging Jack.
3. Insert the other end of the USB cable into
the wall charger or a computer's USB port.
4. While charging, the red LED turns on. When
charging is complete, the red LED will turn off.
Your wall charger and USB adaptor cable serve
two purposes:
1. Charging your headset from any A/C wall socket or from a USB port on
your computer (charging time from computer takes longer)
2. Downloading software upgrades from any PC running Windows® XP™,
Vista™ or Windows 7. (see section 4.3 for details).

IMPORTANT:

The cover protecting the micro USB Connector should be kept tightly closed at all
times to prevent moisture from entering the device.
4. BASIC SETUP AND CONFIGURATION

4.1 BASIC FUNCTIONS

DESIRED RESULT
REQUIRED ACTION
Turn On / Off
Press and hold the Mobile Button for at least 3 seconds
On: Three blue flashes and Ascending tone
Off: Three red flashes and Descending tone
Adjust the volume of the
Tap either the Volume Up or Volume Down Button
current audio source
(sets and saves the volume per source)
Mute
Simultaneously tap Volume Up and Volume Down while
any audio is on
Battery Level Indicator
While on standby, press and hold the Volume Up Button
for 3 seconds
Blue light = Battery is fully charged
Red/blue light = Battery is half full
Red light = Battery is almost empty
WARNING: When adjusting the volume do not set it so high that you cannot hear
outside sounds. This could cause dangerous, even life-threatening conditions and is
prohibited in some states.

4.2 STATUS LIGHTS

LED Indication
None
1 blue flash every 3 seconds
2 blue flashes every 3 seconds
1 red flash every 3 seconds
2 red flashes every 3 seconds
Solid red
Status
Headset is off
Standby – No call is in progress
Audio active
Standby – Battery is low
Low battery while audio active
Charging
5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Src-system pour casques c3 pro

Table des Matières