Ego Power+ ST1530E Manuel De L'opérateur page 11

TROUBLESHOOTING
PROBLEM CAUSE
◾
The battery pack is not attached
to the trimmer.
◾
No electrical contact between
the trimmer and battery.
Line trimmer fails to
start.
◾
The battery pack is depleted.
◾
The lock-off button and
trigger are not depressed
simultaneously.
◾
The guard is not mounted on the
trimmer, resulting in an overly
long cutting line and motor
overload.
◾
Heavy cutting line is used.
◾
The motor shaft or trimmer head
is bound with grass.
◾
Line trimmer stops The motor is overloaded.
while cutting.
◾
The battery pack or line trimmer
is too hot.
◾
The battery pack is
disconnected from the tool.
◾
The battery pack is depleted.
SOLUTION
◾
◾
◾
◾
◾
◾
◾
◾
◾
◾
◾
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1530E
Attach the battery pack to the trimmer.
Remove battery, check contacts and reinstall
the battery pack.
Charge the battery pack.
Press down the lock-off button and hold it, then
depress the trigger to turn on the line trimmer.
Remove the battery pack and mount the guard
on the trimmer.
Use recommended nylon cutting line with
diameter no more than 2.4 mm.
Stop the trimmer, remove the battery, and
remove the grass from the motor shaft and
trimmer head.
Remove the trimmer head from the grass. The
motor will recover to work as soon as the load
is removed. When cutting, move the trimmer
head in and out of the grass to be cut and
remove no more than 20 cm of length in a
single cut.
Allow the battery pack or trimmer to cool until
the temperature drops below 67°C.
Re-install the battery pack.
Charge the battery pack.
EN
11