Siemens TI 91 Série Mode D'emploi page 57

The coffee tastes "burnt".
The water filter does not stay in
position in the water tank.
The coffee grounds are not
compact and are too wet.
Water dripped onto the inner
floor of the appliance when the
drip tray was removed.
The drip tray cannot be
removed.
The outlet system cannot be
assembled or disassembled.
Display shows "Fill bean con-
tainer". Display appears
although the bean container
)B is already full, or the
grinder is not grinding any cof-
fee beans.
Display shows: "Empty drip
tray" even if the drip tray is
empty - what to do?
The brewing temperature is too
high
The set grinding level is too fine
or the ground coffee is too fine.
Unsuitable type of coffee.
The water filter is not mounted
correctly.
The set grinding level is too fine
or too coarse, or not enough
ground coffee has been used.
Drip tray removed too early.
The coffee grounds container is
very full.
The coffee grounds slider
becomes stuck.
Incorrect sequence
Beans are not falling into the
grinding unit (beans too oily).
Emptying is not detected when
the appliance is off.
The drip tray is soiled.
Trouble shooting en
Reduce the temperature.
~ "Adjusting beverage settings"
on page 44
Set a coarser grinding level or use
coarser ground coffee.
Change the type of coffee.
Immerse the water filter into water until
no more air bubbles escape; insert the
filter again.
Firmly press the water filter straight
down into the tank connection.
Set a coarser or finer grinding level or
use two level measuring spoons of
ground coffee.
Wait a few seconds after the last drink
was dispensed before removing the
drip tray.
Clean the interior of the brewing unit.
~ "Cleaning the brewing unit"
on page 52
Correctly insert the coffee grounds
slider.
Connect the outlet system (with milk
system) first, then connect the milk sys-
tem; alternatively, in the case of disas-
sembly, first remove the milk container
and then remove the outlet system.
Gently tap the bean container. Change
the type of coffee if necessary. When
the bean container is empty, wipe it
with a dry cloth.
When the appliance is switched on,
remove and re-insert the drip tray.
Clean the drip tray thoroughly.
57