Siemens TI 91 Série Mode D'emploi page 40

en Before using for the first time
Setting the water hardness
It is important to set the water hardness
correctly, so that the appliance indicates
accurately when the descaling
programme should be run. The preset
water hardness is level 4.
You can check the water hardness
using the enclosed test strip or by
asking your local water supplier.
Briefly immerse the enclosed test
1.
strip in fresh tap water, leave it to
drip off and read off the result after 1
minute.
Use the rotary selector to set the
2.
water hardness determined.
Confirm with the right navigation
3.
button.
The "Fill bean container" reminder lights
up briefly.
Either confirm with the right
4.
navigation button or wait a few
seconds.
Notes
When the appliance is used for the
■
first time after running a service
program, or if it has not been
operated for a long period, the first
beverage will not have the full aroma
and should not be consumed.
After commissioning the appliance,
■
you will achieve a suitably thick and
stable "crema" only after the first few
cups have been dispensed.
If the appliance is in use for a long
■
period of time, water droplets will
form on the ventilation slots. This is
normal.
The table shows the allocation of the
levels to the different degrees of water
hardness:
Level Degree of water hardness
German (°dH)
1 1-7
2 8-14
40
French (°fH)
1-13
14-25
Level Degree of water hardness
German (°dH)
3 15-21
4 22-30
Subsequent changes to the water
hardness can be made at any time.
~ "Menu settings" on page 48
Filling the bean container
This appliance can be used to prepare
coffee drinks from coffee beans or
ground coffee (not instant coffee).
Open the lid ): of the bean
1.
container )B.
Pour in the beans.
2.
Close the lid again.
3.
Notes
The coffee beans are freshly ground
■
for each brewing.
The coffee beans must be sealed
■
and stored in a cool place to retain
optimum quality.
Coffee beans can be stored in the
■
bean container for a number of days
without losing their aroma. Always
add the ground coffee first prior to
beverage preparation. ~ "Preparing
coffee using ground coffee"
on page 42
Filling the water tank
Important: Fill the water tank with fresh,
cold, still water on a daily basis. Prior to
operation, check whether the water tank
has been sufficiently filled.
Hold the recessed grip )" on the
1.
side of the water tank `and gently
tilt out the water tank to the side.
Use the handle to remove the water
2.
tank.
Insert the water filter. ~ "Inserting
3.
or replacing a water filter"
on page 49
French (°fH)
26-38
39-54