Rear Panel Introduction; Monitor Operation - Gima CMS-M Notice D'utilisation

31

3.3 Rear Panel Introduction

1) Stethoscope Probe
function: collect heart-beat signal.
2) Electrode
function: collect electrical signal of the body.
Chapter 4
OPERATING GUIDE

4.1 Monitor Operation

4.1.1 Auscultation and ECG Monitor
1) Let the patient laying down.
2) Daub some medical conductive paste to the surface of the three electrodes
well-proportioned.
3) Turn on the device, it will enter into the ECG measurement interface (do not
connect the oximeter probe to the device)
4) Hold the device and stick to the chest of patient. All the electrodes should
stick to the kin upon heart. It can display the real-time ECG and heart rate while
monitoring each auscultation section by earpiece (the device has the ability of
automatic magnification, ECG waveform can be magnified automatically).
5) When the device is testing,press the "Power switch" shortly to pause the ECG
waveform , so the operator can observe it carefully. Press it again to show the
waveform again.
6) Press the "Power switch" Long to turn off the device after measuring.
Attention:
 Please check the device before using, and confirm that it can work normally.
 When testing the ECG, keep the device in tranquil environment.
 The device should be in a proper position, or else it may result in inaccurate
measure.
 When testing the ECG, the electrodes must be assured to connect with
the body thoroughly and stably.
 The device should not be used at the same location or limb which has arterial
catheter or blood pressure cuff or receiving intravenous injection.
 If only to use the auscultation function, medical conductive paste is not
needed, you can measure directly through the sensor which connects
with the body thoroughly and stably.
ENGLISH