Storage; Troubleshooting - Eurotops YT6601-02 Manuel De L'utilisateur

GB
1 Run the snow thrower for a few minutes to melt away any snow on the
snow thrower.
2 Disconnect the extension cord from the snow thrower.
3 Examine the extension cord closely for signs of wear or damage. Replace
it if it is worn or damaged.
4 Examine the snow thrower carefully for worn, loose, or damaged parts.
Check connections and screws and tighten if necessary.
5 Store the unit, along with the disconnected extension cord, in a locked, dry
place our of the reach of children to prevent unauthorized use or damage.
Cover loosely with a tarp for added protection.
Problem
Motor does not start
Poor results
Abnormal vibrations
Motor shuts off during
operation

Storage

Troubleshooting

Possible causes
Unit not plugged in.
No electricity
Defective cable
Drive belt worn
damaged.
Auger worn or damaged
Discharge chute blocked
Drive belt worn
damaged.
Auger worn or damaged
Scrapper blade worn or
damaged
Current too high
41
remedy
Plug in the unit
Check power supply
Check cable. Repair or
replace if required.
or Replace the drive belt
Replace the
Ensure the screws and
nuts are properly tighten
Switch off the
thrower and clean the
discharge chute
or Replace the drive belt
Replace the
Ensure the screws and
nuts are properly tighten
Replace the
blade. Ensure
screws are
tighten.
Push reset
restart the snow thrower
auger.
snow
auger.
scraper
the
properly
button,