Eurotops YT6601-02 Manuel De L'utilisateur page 37

GB
After clearing the snow, continue to run the snow thrower for a few minutes to
prevent ice from freezing on moving parts. Then switch off the motor, wait for
all moving parts to stop, and wipe the ice and snow from the snow thrower with
a clean rag.
WARNING: To avoid serious personal injury, do not use hands or feet to
unclog the chute. Before unclogging the chute, shut off the snow thrower and
disconnect from the power supply. Wait for the auger to stop turning. Clean
out the chute with a wooden stick such as a broom handle.
If the snow thrower should start to vibrate abnormally, immediately stop the
motor and check for the cause. Vibration is generally a warning of trouble.
Look behind and use care when backing up with the snow thrower.
For large areas a definite pattern of operation is required to thoroughly clean
an area of snow. These patterns will avoid throwing snow in unwanted places
as well as eliminating a second removal of snow.
Pattern A: Throw the snow to the right or left side where it is possible. For
areas such as a long driveway it is advantageous to start in the middle. Plow
from one end to the other, throwing snow to both sides.
Pattern B: If the snow can only be thrown to one side of the area to be cleared,
start on the opposite side.
Overload Protection
The reset button will be tripped and will automatically shut down the snow
thrower if the circuit is overloaded. To restart, press the reset button and follow
the steps provided for turning on the snow thrower. (Fig. 11)
36