Eurotops YT6601-02 Manuel De L'utilisateur page 36

GB
Direct the discharge to the right or left by turning the discharge chute with the
chute crank. The chute can be adjusted up to 180 degrees.
- First loosen the crank knob by turning it counter-clockwise.
- Turn the crank clockwise to direct the discharge to the left; counterclockwise
to direct the discharge to the right.
- Tighten the crank knob by turning clockwise to secure the discharge chute in
the desired direction.
The chute deflector on the top of the discharge chute controls the height of
the discharge. Loosen both of the T-knobs to raise or lower the deflector to
the desired height and tighten the T-knobs to secure the deflector. NOTE:
Do not over-tighten the T-knobs.
For the most efficient snow removal throw the snow downwind and
slightly overlap each swath.
Push the snow thrower forward at a comfortable rate of speed, yet slow
enough to clear the path completely. The width and depth of the snow
determines your forward speed.
Start your clearing path near the electrical outlet and work outward, throwing
snow in a back and forth motion.
When turning at the end of a swath, step over the cord and turn the snow
thrower. Use the wheel on one side as the pivot point. Slightly tilt the snow
thrower on this pivot point while turning.
The snow thrower can remove up to 30cm deep in one pass. To shave down
larger banks of snow, lift the snow thrower by the primary and auxiliary
handles and place the snow thrower on the bank. Let the weight of the
snow thrower shave down the bank by rocking it in a back-and-forth motion.
When clearing steps, hold the snow thrower by the primary and auxiliary
handles and use a swinging or sweeping motion.
Clear snow often, before it gets too deep. It is best to remove the snow as
soon as possible after it falls.
Some parts of the snow thrower may freeze under extreme temperature
conditions. If parts freeze while the snow thrower is in use, stop the snow
thrower, unplug the extension cord and inspect for frozen parts. Free all parts
of ice before restarting or operating the snow thrower. Do not attempt to
operate the snow thrower with frozen parts or try to force controls that are
frozen.
35