Eurotops YT6601-02 Manuel De L'utilisateur page 32

GB
1. Align the holes in the lower handle section with those in the handle brackets.
(Fig. 1)
2. Secure the handle to the handle brackets with the U-bolts and wingnuts.
Make sure the wingnuts are tightened. (Fig. 2)
3. Following the same instruction to assemble the upper handle. (Fig.3)
Note: Do not over –tighten the joint fixing knobs.
4. Secure the power cord is clipped to the handle with the cable clips.
5. Remove the spring pin from the crank rod (Fig4)
31