Maintenance - Eurotops YT6601-02 Manuel De L'utilisateur

GB
Before carrying out maintenance operations, disconnect power supply.
Regular cleaning and maintenance of your snow thrower will ensure efficiency
and prolong the life of the product.
Check all fasteners at frequent intervals for proper tightness to be sure the
snow thrower is in safe working condition.
After each use, let the motor run for a few minutes so that moving parts do not
freeze. Then shut off the motor, wait for all moving parts to stop, and wipe the
ice and snow from the snow thrower. Rotate the chute crank several times to
remove snow.
Only use a cloth soaked with hot water and a soft brush to clean the snow
thrower. Never wet or spray water on the machine!
Do not use detergents or solvents as these could cause irreparable damage
to the snow thrower. Chemicals can destroy the plastic parts.
To protect the snow thrower from corrosion when storing for long periods,
lightly oil the metal parts.
Store the appliance in a dry area out of reach of children.
For the user's safety, worn or damaged parts must be replaced. Replace
with original replacement parts only. Parts from another snow thrower may
not fit properly causing an unsafe situation.
Lubricating the snow thrower
You do not need to lubricate the snow thrower. All of the bearings are sealed
and were lubricated at the factory for the life of the snow thrower.
Replacing the rubber plates (Fig.12)
- Detach the worn rubber plate by removing the two sets of nuts, bolts, and
washers used to secure it.
- Install the new rubber plate.
- Insert the bolt with the small flat washer into the corresponding holes on
each end of the rubber plate. Use a large flat washer and locknut to
secure the bolt on each end.
- Install the other rubber plate in the same manner.

Maintenance

37