Operation; Turning On And Off; Removing Snow - Eurotops YT6601-02 Manuel De L'utilisateur

GB

Operation

If working on pebbles, gravel or unpaved surfaces -To avoid throwing loose
surface material along with the snow, push down on the handle to raise the
scraper at the base of the unit above the pebbles or gravel. The
manufacturer is not liable for any damage or injury resulting from misuse.

Turning On and Off

WARNING: The auger starts rotating immediately after the snow thrower
is switched on. Keep hands and feet away from the auger.
To switch ON, make sure the auger is not touching any surface, and press
the switch Button (10) then squeezing the handle bar (11)
Once the snow thrower is started you can release the switch Button.
To switch Off, simply release the handle bar (11)

Removing snow

Before starting work, thoroughly inspect the area where the equipment is to be
used and remove all doormats sleds, boards, wires and any other foreign
objects.
Check the condition of the snow thrower before operating it to ensure that the
auger turns freely.
Check the auger for wear and tear at regular intervals.
Make sure all fasteners on the snow thrower (screws, nuts, etc.) are fully
tightened.
Position the discharge chute so that snow will discharge in a safe direction. Do
not direct the discharge towards people or areas where property can be
damaged. Keep children, pets and others away for the work area. Do not walk
in front of the snow thrower when it is running.
34