GE GFMN110 Manuel D'installation page 36

INSTALLING THE STACK BRACKET KIT
36
1. Remove the Dryer Leveling
Legs
A. Carefully lay the dryer on its side.
Use the packing material so you
don't scratch the finish on the dryer.
B. Use an open-end wrench or pliers to
remove the dryer leveling legs.
Back out and remove
all 4 leveling legs
2. Install Rubber Pads to Dryer
Base
Locate the 4 rubber pads in the parts
package. Remove the adhesive backing
and firmly place over on the bracket
where you removed the leveling legs.
3 I . s n a t l l B
A. Align the holes in the left bracket
with the holes in the bottom left
corner of the dryer. Use a Phillips
screwdriver to install the 2 #12 x 1"
tapping screws.
B. Repeat the above step with the right
bracket on the bottom right corner
of the dryer.
C. Set the dryer upright.
NOTE: Make sure to set the dryer on
a r k c t e o t D y r r e
www.GEAppliances.ca
a piece of packing material so the
brackets that are attached to the
bottom of the dryer do not damage
the floor.