Changing The Light Bulbs; Cleaning The Hood; Special Accessories - AEG DE3161-ML Mode D'emploi

Warning
• Failure to observe the instructions on cleaning the unit and changing
the filters will cause a fire hazard. You are therefore strongly
recommended to follow these instructions.
• The manufacturer declines all responsibility for any damage to the
motor or any fire damage linked to inappropriate maintenance or
failure to observe the above safety recommendations.

Changing the light bulbs

• Disconnect the cooker hood from the mains supply.
Prior to touching the light bulbs ensure they are cooled down.
• Extract the extractable drawer.
• Remove the grille
Note: lamps are accessible also by
removing the light shield, these are
supplied with side lock/unlock plastic
spring, grasp it to remove the light
shield. Fig. 5
• Replace the old bulb with a new one of
the same type.
• Refit the lamp cover/grille.
• If the light does not come on, make
sure the bulb has been inserted correctly before contacting your
local Service Force Centre.

Cleaning the hood

• Clean the outside of the hood using a damp cloth and a solution of
water and mild washing up liquid.
• Never use corrosive, abrasive or flammable cleaning products or
products containing bleach.
• Never insert pointed objects in the motor's protective grid.
• Only ever clean the switch panel and filter grill using a damp cloth
and mild washing up liquid.
• Clean all the plastic parts with a soft cloth soaked in warm water
and neutral soap.
• It is extremely important to clean the unit and change the filters at
the recommended intervals. Failure to do so will cause grease
deposits to build up that could constitute a fire hazard.

Special accessories

Charcoal filter type 29 Attention! 341 D: two charcoal filters
Fig. 5
DE 3161: one charcoal filter
57