Changing The Light Bulbs; Cleaning The Hood; Special Accessories - AEG DK 3160 Notice D'utilisation

Warning
• Failure to observe the instructions on cleaning the unit and changing
the filters will cause a fire hazard. You are therefore strongly
recommended to follow these instructions.
• The manufacturer declines all responsibility for any damage to the
motor or any fire damage linked to inappropriate maintenance or
failure to observe the above safety recommendations.

Changing the light bulbs

• Disconnect the appliance from the power supply.
• Warning! Make sure lamps are cold before touching them.
• Remove the clip that secures the lamp cover, then prise off using a
small screwdriver or other suitable tool.
• Replace the burnt-out bulb. Use a 40W max (E14) bulb only.
• Refit the lamp cover and secure in place with the clip.
Note: the lamp can also be accessed by removing the grease
filters, but removing the lamp in this way is more difficult.

Cleaning the hood

• Clean the outside of the hood using a damp cloth and a solution of
water and mild washing up liquid.
• Never use corrosive, abrasive or flammable cleaning products or
products containing bleach.
• Never insert pointed objects in the motor's protective grid.
• Only ever clean the switch panel and filter grill using a damp cloth
and mild washing up liquid.
• It is extremely important to clean the unit and change the filters at
the recommended intervals. Failure to do so will cause grease
deposits to build up that could constitute a fire hazard.

Special accessories

Charcoal filter TYPE 29
64
Fig. 5