Changing The Light Bulb; Changing The Upper Light - Dd 8765 - AEG DD 8765 Notice D'utilisation

Warning
• Failure to observe the instructions on cleaning the unit and changing
the filters will cause a fire hazard. You are therefore strongly
recommended to follow these instructions.
• The manufacturer declines all responsibility for any damage to the
motor or any fire damage linked to inappropriate maintenance or
failure to observe the above safety recommendations.

Changing the light bulb

• Disconnect the cooker hood from the mains
supply.
• Prior to touching the light bulbs ensure they are
cooled down.
• Remove the lamp, use a screw driver as a lever.
Fig. 7.
• Replace the old bulb with a new one of the same
type.
• If the light does not come on, make sure the bulb
has been inserted correctly before contacting
your local Service Force Centre.
Changing the upper light – DD 8765
• Disconnect the cooker hood from the mains supply.
• Prior to touching the light bulbs ensure they are cooled down.
• Remove the light cover by
unscrewing the two side screws
(hold the light cover when
carrying out this operation so
that it does not fall).
• Pull the light to the left to remove
it from its seat.
• Replace the old bulb with a new
one of the same type.
• If necessary change the
STARTER (bayonet fixed).
• Refit the light cover.
• If the light does not come on,
make sure the bulb has been
inserted correctly before
contacting your local Service
Force Centre.
62
All manuals and user guides at all-guides.com
Light
Light cover
Fig. 8
Fig. 7
Starter