Charcoal Filter - AEG DK 3160 Notice D'utilisation

Charcoal filter

• The charcoal filter should only be used if you want to use the hood
in recirculation mode.
• Cleaning/replacing the carbon filter
The saturation of the activated charcoal occurs after more or less
prolonged use, depending on the type of cooking and the regularity
of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least every
four mounths.
The carbon filter may NOT be washed or regenerated.
• Fitting
Remove the grease filters.
Fit the charcoalfilters over the motor.
Align the pins R on the cowl with the slots S, then turn the filter
clockwise until it locks in place.
Refit the grease filters. Fig. 4.
• To remove proceed in the reverse order.
• Always specify the hood model code number and serial number
when ordering replacement filters. This information is shown on the
rating plate located on the inside of the unit.
• The charcoal filter can be ordered from your local Service Force
Centre.
R
Fig. 4
R
S
S
*
63