AEG DE3161-ML Mode D'emploi page 64

• Check that the side wall units between which to install the hood are
sufficiently heavy for installing the hood.
Otherwise mount the brackets to use as additional supports:
a. Insert each bracket from the rear inside the hood through the
opposite slots.
b. Fix the brackets with the screws and threaded bushes.
Screw the headless screws halfway.
They will serve to adjust the position of the hood at the moment of
installation. Fig. 7
Note: the position of the brackets can be adjusted during
installation, suitably loosening and retightening the screws that fix
them to the hood.
Rear view
Ø 5x10
Ø 5x18
Fig. 7
64