Before Beginning Installation - AEG DE3161-ML Mode D'emploi

Before beginning installation

• Warning! Do not connect the appliance to the mains until the
installation is fully complete.
• Remove and keep the grille.
Note: This is to be mounted once installation is completed.
• In addition check whether near the installation area of the hood (in
the area accessible also with the hood mounted) an electric
connection to the mains is available and if it is possible to connect a
fumes discharge device to the outside (Extraction mode only).
• Choose the exhaust hole to use- Fig. 6:
Only recirculation mode: use ONLY the top exhaust hole.
Check that this, once installation is completed, is not obstructed and
that there is sufficient space so that the purified fumes and steam
can return easily into the kitchen.
Press with decision to take away the prefractured part (Top or Rear)
that closes the exhaust hole and remove it.
Install the connection ring on the open discharge outlet (bayonet
attachment - (Extraction mode only) or the deflector. (recirculation
mode only).
Top
Rear
Fig. 6
Top
Ø 2,9 x 9,5
Top
Rear
Ø 2,9 x 9,5
63