Tools And Materials; Before You Begin - Kohler 1237791-2-J Guide D'installation Et D'entretien

Tools and Materials

Before You Begin

NOTICE: Adequate floor support must be provided. Note the model number on the components end of
the bath, then visit the product page at kohler.com for additional information.
NOTICE: Do not lift the bath by the piping or blower, or use the piping or blower for structural support
of the bath. To avoid damage to the bath, lift by the rim at the sides of the bath.
NOTICE: Before installing a rim-mount bath faucet, refer to the specification sheet on the bath product
page at kohler.com.
NOTICE: Provide adequate backer board support for a rim-mount faucet; large faucets that may be
inadvertently used as a means of support are not safe for this installation.
NOTICE: This product requires remote blower installation. Refer to the instructions included with the
remote blower kit before proceeding.
NOTICE: For Wireless Music Kit: Refer to the instructions included with the music kit for wiring and
installation details.
IMPORTANT! To ensure a successful installation, install the bath on a level, finished floor.
Observe all local plumbing and building codes.
Unpack and inspect the bath and components for damage. Return the bath and components to the
carton until installation.
To simplify future maintenance, make sure all plumbing and control board connections around the
bath are easily accessible.
Use conduit to route electrical wires from the circuit breaker.
Carefully plan moving the bath into the installation area. This bath will not easily fit through
doorways.
Two people are needed to install this product.
This bath is designed for freestanding installation only.
If installing a rim-mount faucet, make sure there is no interference above or below the rim before
drilling any holes.
Illustrations shown may not look like your actual product but they still apply to this installation.
Kohler Co.
Construction
Adhesive
100% Silicone
Sealant
3
Plus:
• Drop Cloth
• Shims
• 2x4s
• Wood Blocks
• 1/2" (13 mm) Exterior
Grade Plywood
(for Rim-mount Faucet)
1237791-2-J