Kohler 1196030-2-B Guide D'installation Et D'entretien page 6

GFCI-Protected
Receptacle
3. Install Electrical Outlet – United States and Canada
WARNING: Risk of electric shock. Connect the power supply to a properly grounded,
grounding-type receptacle protected by a Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD). Do not remove the plug grounding pin. Do not use a grounding adapter.
Your bath with heated surface is equipped with a cord and plug. The power supply has been wired
at the factory. A qualified electrician must install a GFCI-protected, 120 V, 15 A, grounded outlet.
Locate the outlet behind the bath and within 24" (610 mm) of the power supply.
Plug the power supply into this outlet.
Test Run the Bath
Check all electrical connections and make sure the electrical power to the bath is on.
Operate the user keypad to test the temperature settings.
For additional information on bath operation, refer to the "Operating Instructions" section.
1196030-2-B
Heated
Surface
Power Supply
6
User
Keypad
Kohler Co.