BEBE CONFORT Titan Plus Mode D'emploi page 48

EN
A - Adjustable headrest
B - Shoulder belt slot
C - Shoulder pads
D - 5-point Harness
E - Inlay
F - Harness buckle
G - Harness adjuster button
H - ISOFIX release handle
I - Harness adjuster strap
J - Headrest adjustment handle
K - Top Tether
L - Storage compartment for the manual
M - ISOFIX connectors release button
N - ISOFIX connectors
O - Crotch pad
P - Recline handle
SAFETY
The Bébé Confort Titan Plus is intended for car
use only.
• The car seat is developed for an intensive use of
approximately 12 years.
• Do not use any load bearing contact points other
than those described in the instructions and marked in
the child restraint.
Bébé Confort Titan Plus in the car
• Before buying this product make sure the car seat is
compatible with the vehicle it is to be used in.
• After purchasing, install the seat in your vehicle. If
you encounter any installation problems, contact your
distributor immediately (prior to use).
• It is recommended to adjust to full recline position
before ISOFIX system installation. After correct
installation of the ISOFIX connector and top tether,
adjust to the proper recline position for your child.
I I
48 Titan Plus Bébé Confort
• Remove the car seat headrest if it stops you from
adjusting the headrest of the car seat to the desired
height.
• Make sure to replace the headrest of the back seat of
your vehicle when you remove the car seat.
WARNING:
• Check that the child seat is properly installed. It is
important for your child's safety that you fit the belt
correctly. The vehicle belt must be fixed along the
appropriated markings/ positioning points on the seat.
Please also read the label on the side of the car seat.
Never fit the belt in any way other than as shown.
• When the car seat is installed on the front passenger
seat, we recommend to switch off the front passenger
airbag if your child is sitting in a front-facing position
and place the passenger seat in the rearmost position.
• Use the car seat only on a front-facing seat that is
fitted with an automatic or static 3-point belt that has
been approved according to the ECE R16 standard or
similar. Do NOT use a 2-point belt.
• When installing the car seat, spaces between the
base of the car seat and the vehicle seat are possible
depending on the position of the anchorage points
within the vehicle.
ATTENTION:
• For usage in ISOFIX use the fitting clips for
lower anchorage to the vehicle are not sufficient.
It is essential to fix the "TOP TETHER" to the
upper anchorage point recommended by the car
manufacturer.
• The ISOFIX anchors have been developed to obtain
a safe and easy fixation of the child safety systems
inside the car. Not all cars are equipped with these
anchors although they are standard on more recent
models.
• If in any doubt about the correct installation or use