Assembly; Operation - Gardena 5500/5 inox Mode D'emploi

Masquer les pouces Voir aussi pour 5500/5 inox:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16

3. Assembly

Install foot
(only for use in cisterns):
2
2
Connecting the hose:
5
5
3
3
6
7
4
6
7
Art. 1499
Art. 1489
Art. 1492

4. Operation

Pump water:
9
6
8
a)
>15 cm
>50 cm
1489-20.960.06.indd 11
1489-20.960.06.indd 11
Only when the pump is sited on the ground does the foot have
to be fitted to prevent the pump from taking in any sand or dirt.
1
1. Push the foot
2. Screw the foot
The 40mm (1 1/4") internal thread (Art. 1499: 33mm (1") female
thread) on the outlet of the Deep Well Pump can be converted
if necessary with the pump fitting provided
(1") external thread. The pump can then be connected to the
GARDENA Hose Connection System and the GARDENA
Fitting Art. 1723 / 1724.
1. Screw the pump fitting
tighten it manually until the washer
In Art. 1499 the sealing ring is integrated in the pump fitting
2. Connect pressure hose
3. Tie the fastening rope
rope.
For the best pumping results, connect 25mm (1") hoses with the
GARDENA Suction Hose Fitting Art. 1724 and one hose clamp.
7
If you need to disconnect the hose frequently from the pump,
we recommend using the GARDENA Pump Connection Set
Art. 1752 in connection with a 19mm (3/4") hose.
For the pump to deliver, the inlet filter of the pump must be
submersed at least 15cm in the water.
a) Without the foot, the pump must be fixed at least 50cm
above the ground.
b) If the foot has been fitted (cistern use), the pump may be
placed on the ground.
1. Immerse pump on the fastening rope
The mains power cable must not be subjected to tension.
2. Secure the fastening rope
b)
3. When using the pump in deep wells or shafts (from approx. 5m
deep) guide the connecting cable
6
using clips
4. Plug the power cable
Attention! The pump starts immediately.
1
onto the pump from below.
1
2
to the pump
with the two screws.
3
onto the outlet of the pump and
4
fits closely.
5
to the relevant adapter.
6
to the two eyes
6
6
.
8
along the fastening rope
9
.
8
into a mains socket.
3
to a 33mm
3
.
7
for the fastening
into a well or shaft.
11
11.07.11 10:53
11.07.11 10:53

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

6000/5 inox6000/5 inox automatic

Table des Matières