Error List - TYLOHELO Elite Mode D'emploi

Vibration
The vibration that can be felt when the heater is switched on and off can be disabled using
the slider.
Relay control
Used by Tylö service personnel. A PIN must be entered. When the relay control is
accessed, all operation ceases.
The sauna system features a menu for controlling the adjustment mode. It is set to
Automatic by default, meaning that the system detects which sensor is connected and
adapts to that.
On/Off – all power relays switch on and off at the same time. In a device containing a
lot of stone, this may be preferable.
Split – power relays are switched off one by one. The first switches off at 2 °C below the
defined temperature, the second switches off at the defined temperature, and the third
at 2 °C above the defined temperature. This means no more power than that necessary
to maintain the heat in the sauna is used.
Status
Primarily used by Tylö service personnel. The Status screen displays information about
the system. The information differs depending on the system involved. Total operating
time, room temperature, whether a door switch is fitted and the status of all relays are
always displayed. The water level is also shown for steam and Combi products. The
water temperature and number of cleanings are also shown for steam products. If
multiple steam generators are connected, or for Tylarium models, information about
all products is displayed.

Error list

This list shows any errors that have occurred in the system. It can be deleted using the
Clear button. Press the error code to view the full error code notification.