TYLOHELO Elite Mode D'emploi page 39

Settings (continued)
If the lighting is connected to the device it starts automatically along with the sauna heater, but it can also be
switched on or off manually. Press the button quickly to activate or deactivate, or drag the slider/button to the On/
Off position. When the session is finished the lighting stays on for a further 10 minutes. It then switches off automa-
tically. You can also switch the lighting off manually.
If other accessories are connected, these will be shown under the Lighting button. For more information on access-
ories, see Configure.
Press the session time button to configure the
desired session time in a new window.
Use the Up and Down arrows to change this to the desired session time and
confirm by pressing
The maximum session time is determined by international rules. The maximum session time for
private saunas is six hours. After this time, the sauna must be inspected before it is started via a
program or external switch.
For public devices that are not monitored, a six-hour break is required over the course of 18
hours. These hours may be split up into smaller periods. For example, four hours on, two-hour
break, four hours on, two-hour break, four hours on, two-hour break – resulting in a total of
twelve hours in operation and six hours of breaks.
No restrictions apply to operating times for public devices when no calendar program or delayed
start is used and when the sauna is monitored.
The device is set to Private by default. This can be changed under Configure.
. To cancel press X.